| Official Luthiers Forum! http://www-.luthiersforum.com/forum/ |
|
| Chris Paulick's Motorizing A Radius Sanding Dish http://www-.luthiersforum.com/forum/viewtopic.php?f=10117&t=18217 |
Page 1 of 1 |
| Author: | Chris Paulick [ Sat Aug 02, 2008 11:29 am ] |
| Post subject: | Chris Paulick's Motorizing A Radius Sanding Dish |
| Author: | ChuckH [ Mon Sep 01, 2008 10:10 am ] |
| Post subject: | Re: Chris Paulick's Motorizing A Radius Sanding Dish |
Great video's on YouTube Chris. Keep them coming and thanks for sharing your tutorials. |
|
| Author: | Danny R. Little [ Mon Nov 03, 2008 4:02 pm ] |
| Post subject: | Re: Chris Paulick's Motorizing A Radius Sanding Dish |
Chris: Nice jigs. I like the segment truer upper. It will work for bowl making as well. Thanks |
|
| Author: | rich altieri [ Mon Nov 03, 2008 9:15 pm ] |
| Post subject: | Re: Chris Paulick's Motorizing A Radius Sanding Dish |
Chris I am always amazed at the inguinity people come up with. Cool idea, easy to make and use. WIll be adding it to my to do list this winter. Tanks |
|
| Author: | Chris Paulick [ Tue Nov 18, 2008 1:45 pm ] |
| Post subject: | Re: Chris Paulick's Motorizing A Radius Sanding Dish |
Make sure to use casters or rollers that have bearings. As the cheap ones that are just plastic on a shaft will eventually wear out from heat friction. |
|
| Author: | Chuck [ Thu Feb 19, 2009 5:24 pm ] |
| Post subject: | Re: Chris Paulick's Motorizing A Radius Sanding Dish |
Thanks for video. This is a great idea. I will be making one before I start my guitar. Chuck |
|
| Author: | JJ Donohue [ Thu Feb 19, 2009 6:17 pm ] |
| Post subject: | Re: Chris Paulick's Motorizing A Radius Sanding Dish |
Nice, Chris. Having a motorized sanding operation sure would go a long way in saving my back and shoulder from "driving the bus". Couple of questions... 1) How long does it take you to sand the rims and kerfed linings. 2) Have you designed a method of holding the rim in the mold while sanding? 3) How safe is this design for the router motor itself? It seems to me that router motors are designed for intermittent operation for a few minutes rather than a lot of minutes at a time. Have you seen any evidence of over-heating? Thanks for posting! |
|
| Author: | Andy Birko [ Tue Feb 24, 2009 8:35 am ] |
| Post subject: | Re: Chris Paulick's Motorizing A Radius Sanding Dish |
I posted this elsewhere in the forum but thought I'd post here too just to illustrate another concept. Motor is only a 1/6 HP oldie I picked up for $20. Does the job just fine. This picture shows me sanding a 25' dome into a bandura rim. Used it for my guitar and it worked great. Went from fully flat rims to profiled (with linings, heal and tail blocks already attached) in about 5min. |
|
| Page 1 of 1 | All times are UTC - 5 hours |
| Powered by phpBB® Forum Software © phpBB Group http://www.phpbb.com/ |
|